Type; Fuse - Craftsman 917.254740 Owner's Manual

& ADJUSTMENT
INPUT PULL[Y
FIGURE 33
4. Motion Drive Belt Replacement
Park the tractor on level area. Engage parking
brake.
NOTE: BELT INSTALLATION DECAL UNDER LEFT
FOOT R EST.
a, Remove mower (page 23).
b, Remove belt from (3) stationarv idlers
(Fig. 33).
c. Re/ease parking brake, Puff belt as far as
possible over top of clutching pulley (Fig, 33),
d. Reset parking brake, Puff belt over top o/
clutching pulley.
e. P/ace top side of bett between blades of
fan and rotate fan counterclockwise /P ..... )
(Fig, 34), Remove belt from #_put pulley
(Fig, 34).
f, Using a 9/16" wrench, remove clutch /ocator
(Fig. 33- Inset),
g. Disconnect clutch wire harness,
h, tnsta// belt by reversing above procedure,
NOTE: REPLACE ONLY WITH BELT LISTED tN
REPAIR PARTS SECT!ON OF THtS MANUAL.
5. Fuse Replacement
Fuse is Located under dash to the left of the
battery, If Fuse replacement is necessary, Re-
place with 30 Amp Automotive type plug in Fuse.
Fuses can be purchased at al! Sears Service
Centers and most retail stores
./ TRACTION
- /
DRtV[ GELT
FIGURE 34