Installing And Configuring Ip Phones - Nortel 1000 Branch of?ce Installation And Commissioning Manual

264 MG 1000B telephones
•
•
This chapter provides information on installing and configuring IP Phones,
analog devices, and digital devices at the Branch Office.
Installing and configuring IP Phones
All MG 1000B IP Phones must be configured in the main office on the main
office Call Server (see
They are also configured on the MG 1000B CPPM for survivability purposes.
Automatic data synchronization is not carried out between the main office
Call Server and MG 1000B CPPM. However, refer to
data using TM 3.01" (page
from the main office to the MG 1000B.
Configuring IP Phones is done in two stages – IP Phone data configuration,
and Branch User-specific data configuration. The configuration can be done
in two ways:
•
•
Alternatively, use any method to install the IP Phone and then configure
the Branch User information.
This section contains instructions for installing IP Phones in all three ways:
Set-Based, TM 3.01, or overlays.
When the telephone line is inserted into the jack, the IP Phone contacts the
MG 1000B TPS for registration, and receives the firmware and features
of the Branch Office.
Copyright © 2007, Nortel Networks
.
Analog (500/2500-type) telephones and devices –
(page 288)
Digital telephones and devices –
"MG 1000B IP Phone configuration" (page
Set-based installation - Use the keypad interface on the IP Phone to
enter the data.
— Enter the IP Phone data (follow the procedure
Set-Based Installation" (page
— Enter the Branch User-specific data (follow the procedure
25 "Configuring a Branch User" (page
Use TM 3.01 or LD 11 to enter all data.
WARNING
Do not plug the IP Phone into an ISDN connection. Severe
damage can result. Consult the system administrator to ensure
that the telephone is plugged into a 10/100BaseT Ethernet jack.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
"Digital devices" (page 288)
274)for procedures to transfer IP Phone data
267)).
271)).
"Analog devices"
218)).
"Transferring IP Phone
Procedure 24 "Using
Procedure