Configuring Cs 1000; Contents; Before You Begin; Cs 1000 Sip Configuration And Udp Location Dialing - Nortel 1000 Con?guration guide Manual

Configuring CS 1000

Contents

This section contains information about the following topics:
"Before you begin" (page 49)
"CS 1000 SIP configuration and UDP location dialing" (page 49)
"Configuring the Converged Desktop User" (page 66)

Before you begin

Some values in these instructions are taken from the values in
network configured in this document" (page
plans described in
for mixed networks" (page
applications.
Before you begin configuring CDS on the CS 1000, you must have a
SIP Trunk Gateway configured. The SIP Trunk must have Insert ESN
Access Code (INAC) configured for incoming LOC calls. Refer to IP Peer
Networking Installation and Commissioning (NN43001-313) for details.
Ensure that CDS calls are routed over the SIP Trunk Gateway that is
associated with the CDS application.
CS 1000 SIP configuration and UDP location dialing
Configuring the Call Server
The following is a summary of the tasks in this section:
1.
Communication Server 1000 to MCS 5100 Converged Desktop Type 2 Configuration Guide
Copyright © 2005-2008, Nortel Networks
.
"Configuring the Call Server" (page 49)
"Configure the Signaling Server usingCS 1000 Element Manager" (page 57)
"Verifying configuration" (page 64)
"Examples of dialing and numbering plan configuration
"LD 15 Configure CLID and HLOC." (page
Nortel Communication Server 1000
NN43001-321 01.05 Standard
Release 5.0 15 February 2008
ATTENTION
48), and from example numbering
37). Note that actual values may differ between
"Description of the
50).
49