INSTALLING THE RIP FENCE (Figure 6)
1. Place rip fence on the top of the cutting
table and clamp both ends.
NOTE: The rip fence can be placed on either
the left or right side.
INSTALLING
THE MITER GUIDE (Figure 7)
1. The miter guide is designed to fit on top of
the rip fence. Simply place notch in miter
guide onto the top of the rip fence,
NOTE: The miter guide can be placed on
either the left or right side,
IMPORTANT:
ALWAYS turn off the saw and remove the plug from the outlet
BEFORE
adding or removing accessories and making adjustments.
I
WARNING:
Failure to unplug the saw could result in accidental starting
causing possible serious personal injury.
BEFORE STARTING
THE SAW (Figure 8)
1. Remove the blade guard.
2. Open the right cutting table and fill the
water reservoir to the recommended
level.
DO NOT fill above the lines.
NOTE: ALWAYS keep enough water in the
reservoir when operating the saw.
DO NOT let the saw run dry.
3. Re-attach the blade guard and close the
right cutting table.
IMPORTANT:
ALWAYS completely drain the
water reservoir after each use,
Fig. 8
11