Craftsman 358.797110 Operator's Manual page 4

4.Align r ibwith groove and insert
elbow into blower outlet.
5.Secure the tubes b yturning the
knob clockwise.
6.Proceed toALL U NITS - TUBE AS-
SEMBLY.
GAS UNITS W ITH KNOB ( 2)
1.Stop engine and wait u ntil impeller
has completely stopped turning.
2.Remove all t ubes o rother attach-
ments from unit.
3.Insert the notched
end of the adapt-
er into elbow; push parts together
until the adapter snaps into place.
Notched End Elbow
4. Align the rib on the adapter with the
slot on the inside of the collar; slide
the adapter into the collar.
Collar
!
D4-
Elbow
Rib _
!
Adapter
5. Align the rib on the collar with the
groove in the blower outlet; slide the
collar into place.
Blower Outlet
J Collar
3. Insert the notched end of the adapt-
er into elbow; push parts together
until the adapter snaps into place.
Notched End Elbow
4. Align the rib on the adapter with the
groove in the blower outlet; slide the
adapter into place.
Blower Outlet U
"oove
Rib
5. Secure the tubes by turning the
knob clockwise.
6. Proceed to ALL UNITS - TUBE AS-
SEMBLY.
ELECTRIC UNITS WITH THREADS
1. Stop the motor, disconnect power
source, and wait until impeller has
completely stopped turning.
2. Remove all tubes or other attach-
ments from unit.
3. Remove spacer ring from elbow.
4. Thread the small end of the elbow
into the blower outlet until the elbow
stop is about 3/8 inch from blower
outlet.
Groove \
Rib
6. Secure the tubes by turning the
knob clockwise.
7. Proceed to ALL UNITS - TUBE AS-
SEMBLY.
GAS UNITS WITH KNOB (3)
1. Stop engine and wait until impeller
has completely stopped turning.
2. Remove all tubes or other attach-
ments from unit.
5. Proceed to ALL UNITS - TUBE AS-
SEMBLY.
ELECTRIC UNITS WITH TUBE
RELEASE BUTTON
1. Stop the motor, disconnect power
source, and wait until impeller has
completely stopped turning.
2. Remove all tubes or other attach-
ments from unit.