Panther (10.3) And Jaguar (10.2); Rendezvous - Oki C810n Network User's Manual

Panther (10.3) and Jaguar (10.2)

Rendezvous

This utility is called Print Center on Mac OS X
10.2.x.
If your printer is already listed, your Mac may
already have discovered the printer before you
installed the Oki software. In this case, the
printer may be using the incorrect PPD file or
may not have the correct hardware options
configured. You should delete the printer, quit
Printer Setup Utility, and re-launch the utility
before continuing.
If you have not already done so, run the Oki software installer
before following the steps below.
1. Start the Printer Setup Utility.
This is located in the Applications > Utilities folder.
2. Click Add....
3. From the pop-up menu, choose Rendezvous.
4. Select the printer you wish to connect to.
5. Click Add.
6. Click the Printer Setup Utility menu, and choose Quit
Printer Setup Utility.
After adding the printer, you should configure printer hardware
options. Refer to "Configuring Printer Hardware Options" on
page 82.
NOTE
Network User's Guide
79