HP Surestore E Disk System FC10 Service Manual page 100

Problem HWEvent
Description Category
Disk fault Critical
LED is on
Power supply Critical
LED is amber
Fan LED is Critical
amber
LCC fault Critical
LED is on
LCC fault none
LED is on
and the disk
system beeps
GBIC fault Critical
LED is on
100
Status
LED
State SAM
Fault Critical (See STM
LED on Disk Tool)
Amber Critical Critical
Amber Critical Critical
LCC Critical Critical
Fault
LED on
LCC none none
Fault on
Tx Fail none none
LED on
STM Probable Cause/Solution
Disk hardware is faulty. Replace the
disk.
– An incompatible or defective
component caused a temporary
fault.
– Power supply hardware is faulty.
Unplug the power cord and wait for the
LED to turn off. Reinsert the power
cord. If fault persists, replace the power
supply.
Fan has slowed or stopped. Replace
the fan.
LCC hardware is faulty. Replace the
LCC.
The Enclosure ID on the installed LCC
does not match the Enclosure ID on the
peer LCC. Reset the Enclosure ID and
reinsert the LCC.
– GBIC transmission circuit has failed.
– GBIC is not receiving power.
Reseat the GBIC. If problem persists,
replace GBIC. If the replacement GBIC
fails, contact HP technical support.