HP Surestore Disk Array 12h - And FC60 Manual page 116

Restriction
The Disk Array FC60 is not supported as a boot
device on Windows NT.
There are known display problems with using
256 colors. A brownish hash pattern is
displayed on the windows and in the online
Help.
Clicking on the vertical scroll arrows (either up
or down) causes the scroll box to move all the
way to the opposite end of the scroll bar.
To avoid losing access to data, do not attempt
to immediately re-open the Array Management
Window after performing a firmware upgrade.
During the upgrade, you are prompted to close
the Array Management Window. It then takes
approximately five minutes for the upgrade to
complete.
There are limits to how much drive space
capacity you can have in a single volume
group. For example, with 73.4 GB drives, the
maximum number of drives that can be
configured in a single volume group is 29.
During RDAC installation, you will see the
Digital Signature Not Found message.
116
Workaround
None
To avoid this problem in online Help, do not use
the scroll bar or the up/down arrow keys when
scrolling. To navigate within Help, click in the
scroll area above or below the scroll bar or use
the Page Up and Page Down keys.
Recommended display setting of 1024 x 768
pixels with 64K colors. The minimum display
setting allowed is 800 x 600 pixels with 256
colors.
This is a known defect in the Java Runtime
Environment.
Click the scroll box and slide it until you reach
the desired position in the window.
After you respond to the prompt to close the
AMW, wait approximately five minutes, then
use SM60 to confirm that the firmware has
successfully upgraded on both controllers
before re-opening the Array Management
Window.
None.
We have tested this software, and it does work
correctly with Windows.
You can select Yes, and continue the
installation.