Diagclearerror - HP Surestore 6164 - Switch Reference Manual

diagClearError

Synopsis
Availability
Description
Operands
Example
See Also
Telnet Commands
Clear the software flag to allow for retest.
diag
diagClearError [port]
admin
Use this command to clear the
port is BAD or OK. The current flag settings are displayed by using the
command. This command resets the flag to allow the bad port to
diagShow
be retested; otherwise the test skips the port.
This command does not clear the error log entry. Instead, it generates the
message for each port software flag cleared. For
DIAG-CLEAR_ERR
example:
0x10f9d560 (tShell): Apr
Error DIAG-CLEAR_ERR, 3,
Pt13 (Lm3) Diagnostics Error Cleared
Err# 0001
This command has the following operand:
Specify the port where you want to reset the
port
software flag. The default (if no operand is specified) is
to clear all bad port flags. This operand is optional.
To clear the diag software flag:
switch:admin> diagClearError
0x10f9d5e0 (tShell): Apr
Error DIAG-CLEAR_ERR, 3,
Pt7 (Lm1) Diagnostics Error Cleared
Err# 0001
diagShow
software flag that indicates whether a
diag
9 08:35:50
6 13:25:36
diag
57