HP StoreOnce B6000 Series Manual page 15

The following figure shows a configuration with a single host. The Installation wizard has been
run on Host 1. The HP StoreOnce Backup System automatically generates a library for the host.
The user may specify the number of slots during installation.
Figure 1 Device configuration with one host
By default, only one device is visible to the host, the iSCSI library that has been configured
for it during installation. Data from each host goes to its corresponding iSCSI library.
Each backup device is visible only to the host for which it has been configured.
A host may have multiple devices configured for it on the HP StoreOnce Backup System, but
this means fewer hosts may be connected (not illustrated).
The following figure shows a configuration with three hosts. The Installation wizard automatically
generates a library for each host. The user may specify the number of slots during installation.
Figure 2 Device configuration with multiple hosts
VTL devices on an Ethernet network (not HP B6000) 15