Checking The Status Of A Power Supply; Checking Temperature Status - Brocade Communications Systems StoreFabric SN6500B Troubleshooting Manual

Checking the status of a power supply

1. Connect to the switch and log in as admin.
2. Enter the psShow command:

Checking temperature status

1. Connect to the switch and log in as admin.
2. Enter the tempShow command:
Fabric OS Troubleshooting and Diagnostics Guide
53-1002751-01
Equipment status
Fan 1 is Absent
Fan 2 is Ok, speed is 6553 RPM
Fan 3 is Ok, speed is 6367 RPM
The possible status values are:
•
OK—Fan is functioning correctly.
•
Absent—Fan is not present.
•
Below minimum—Fan is present but rotating too slowly or stopped.
•
Above minimum—Fan is rotating too quickly.
•
Unknown—Unknown fan unit installed.
•
FAULTY—Fan has exceeded hardware tolerance.
The output from this command varies depending on switch type and number of fans present.
Refer to the appropriate hardware reference manual for details regarding the fan status. You
may first consider re-seating the fan (unplug it and plug it back in).
switch:admin> psshow
Power Supply #1 is OK
V10645,TQ2Z6452916
Power Supply #2 is faulty
V10704, TQ2J7040124
The possible status values are:
•
OK—Power supply functioning correctly.
•
Absent—Power supply not present.
•
Unknown—Unknown power supply unit installed.
•
Predicting failure—Power supply is present but predicting failure.
•
FAULTY—Power supply is present but faulty (no power cable, power switch turned off, fuse
blown, or other internal error).
If any of the power supplies show a status other than OK, consider replacing the power supply
as soon as possible. For certain switch models, the OEM serial ID data displays after each
power supply status line.
switch:admin> tempshow
Sensor State
ID
=================================================
1 Ok
2 Ok
,60-0300031-02, B, QCS ,DCJ3001-02P
,60-0300031-02, B,CHRKE,SP640-Y01A
Centigrade Fahrenheit
28 82
16 60
10
, A,TQ2Z64529
,C ,TQ2J7040
109