HP StorageWorks XP12000 - Disk Array Site Preparation Manual page 62

1. If shipped in a wooden crate:
a.
Using an 11mm (7/16") ratchet or wrench, remove the six lag screws at the base of the
crate.
b.
Using the claw end of a claw hammer, remove the crate clamps, and then remove the crate
panels.
WARNING!
Crate clamps are under tension. Wear safety glasses and hold onto the clamp with
your free hand during removal.
Steps 2 through 5 refer to
1. Polyester bands
2. Pallet nails
3. Carton fasteners
62 Delivery and unpacking
Figure 15.