Installing A Power Supply And Cooling Module - Dell EQUALLOGIC PS6500 Hardware Manual

PS6500 Hardware Maintenance Maintaining Power Supply and Cooling Modules
Note: You can detach one side of the cable management system from the rear chassis flange and carefully pull it
away from the rear of the array to provide access to the power supply and cooling modules.
To remove a power supply and cooling module:
1. Disconnect any power cables from the module.
2. Squeeze together the module latches to release the handle and then rotate the handle downwards. This
disengages the module from the chassis. See Figure 4-4 (module shown alone for clarity).
Figure 4-4: Opening the Handle
3. Hold the handle and carefully slide the module from the slot. See Figure 4-5.
Figure 4-5: Removing a Power Supply and Cooling Module
When you replace a failed power supply and cooling module, return the module in the packaging in which the
replacement module was shipped. Contact your PS Series support provider for information about returning
hardware.

Installing a Power Supply and Cooling Module

To install a power supply and cooling module:
1. Orient the power supply and cooling module so that the power plug is at the bottom.
4-4