Installing A Power Supply And Cooling Module - Dell EqualLogic PS4000 Hardware Maintenance

PS4000 Hardware Maintenance

Installing a Power Supply and Cooling Module

Caution: The module is heavy; support it with two hands.
To install a power supply and cooling module in an array:
1. Attach an electrostatic wrist strap, as described in Using an Electrostatic Wrist
Strap on page 1-5.
2. Refer back to Figure 4-2. Squeeze the latches inward (callout 1) to release the
handle and then rotate the handle upward (callout 2).
3. Hold the handle and slide the module into the slot, until you feel resistance.
See Figure 4-4.
Figure 4-4: Installing a Power Supply and Cooling Module
4. Rotate the handle downward until it engages with the latches and the module
is completely inserted. Refer back to Figure 4-2.
5. Attach the power cable to the module. If your PS Series array was shipped
with a power cable, use this cable to meet safety requirements.
4–4
Maintaining Power Supply Modules