Accessing The Cli Through The Ethernet Port (Via A Telnet Session) - HP StorageWorks MSA 2/8 - SAN Switch Installation Manual

Accessing the CLI through the Ethernet Port (via a Telnet Session)

Use these steps to log into the MSA SAN Switch from the Ethernet port.
1. Remove the shipping plug from the MSA SAN Switch Ethernet port.
2. Connect one end of an Ethernet cable to the workstation or to an Ethernet
3. Connect the other end of the Ethernet cable to the MSA SAN Switch Ethernet
4. From your workstation, open a telnet session to the MSA SAN Switch.
5. At the login prompt, enter the user ID. For example:
6. Enter the password for the user:
Note:
change the admin user ID and system password.
7. If the login was successful, a prompt is displayed showing the switch name
MSA SAN Switch 2/8 Installation Guide
network containing the workstation.
port.
The MSA SAN Switch will automatically sense the cable configuration used
(straight or cross over.)
To open a telnet session through the command prompt, enter:
TELNET 10.77.77.77
The login prompt is displayed.
login: admin
The password prompt is displayed.
password: xxxxxx
The default password is password.
For security reasons, the first time you log into the CLI you are requested to
and user ID you are logged in as.
For example:
MSA1000-switch1:admin>
Configuring the MSA SAN Switch 2/8
33