Selecting The Surround Mode; Using Dolby Pro Logic Ii, Dolby Digital And Dts Digital Surround - JVC TH-V70 Instructions Manual

IM PORTANT:
A00,oJ i_lr--1 l
When using the remote control, check to see if its
TV/VCRlmIm I
remote control mode selector is set to the correct CATV/DBS J'
position: _[]
To operate this system, set it to "AUDIO/'rv/vcR."
Selecting the surround mode
The system is so set up in its initial state that it automatically
selects the optimal surround mode for each input signal
(AUTO SURROUND MODE).
Only when you want to change a surround mode selected
automatically, perform the following procedure.
• After having changed the surround mode, turning off the
power or changing sources resumes the auto surround
mode.
From the remote control ONLY:
___TVRETURN FMMODE 100+
ON -- --
SCREEN AUDIO
wvcR
SURROUND
MODE button
Press SURROUND MODE.
The current surround mode is called up and appears on the
display window.
Each time you press the button, the surround mode changes
as follows.
_> PL II MOVIE _> PL II MUSIC _:>LIVE CLUB
_> DANCE CLUB _> HALL _> PAVILION
=:>ALL CH ST. =:> STEREO (surround off)
=:>(back to the beginning)
NOTES:
• When you have set the rearspeakers to "NONE,"you cannot use
the DAP modes and All Channel Stereo. (See pages 60 and 66.)
• When the digital multichannel software such as Dolby Digital or
DTS Digital Surround is played back, the appropriate multichannel
Surround mode is automatically activated ("DOLBY D" or "DTS
SURR"), and you can only turn on or off ("STEREO") the surround
mode.
• For Dolby Digital 2 channel software, you can select "PLII MUSIC,"
"PLII MOVIE," or off ("STEREO") by pressing SURROUND MODE.
Using Dolby Pro Logic II, Dolby
Digital and DTS Digital Surround
Once you have adjusted the sound, the adjustment is
memorized for each source.
From the remote control ONLY:
Sound setting
buttons
2
I_1 _woo_ %OT
TEST
(23
@
SOUND
button
TEST
button
SURROUND
MODE button
Start playing back software.
When playing a conponent connected to the AUX IN or
the DIGITAL IN jack, change the source to AUX or AUX
DIGITAL. (See page 22.)
PressSURROUND MODE to activate
Surround mode.
Each time you press the button, Surround mode turns on
and off (stereo) alternately.
• If you are playing back software encoded with Dolby
Digital multichannel, "DOLBY D" is selected.
• If you are playing back software encoded with DTS
Digital Surround, "DTS SURR" is selected.
• If you are playing back any software other than the
above, you can select "PL II MUSIC" or "PL II MOVIE"
according to the source by pressing SURROUND
MODE.
If you like to adjust sound, go to step 3.
3 Press SOUND.
The 10 keys are activated for sound adjustments.
4 PressTESTto check if you can hear the sounds
through all the speakers at the equal level.
"TEST TONE L" and the corresponding signal indicator
starts flashing on the display window, and the test tone
comes out of the speakers in the following order:
.... A
• 'rfibii:::
÷-...-,N
Left front speaker _> Center speaker _ Right front
speaker _> Right rear speaker _> Left rear speaker
=:>(back to the beginning)
35