Table of Contents
Advertisement
•
Inserting the battery
Install the battery
by inserting
it in the
direction
shown
in the figure.
•
Inserting/removing
an SD card
O
Insert the battery
until it clicks and locks.
•
Charging
the battery
O
DC input terminal
O
Connect
the AC adaptor
to the DC input
terminal.
I_
Connect
the AC cable to the AC
adaptor,
then the AC outlet.
• The status indicator
will flash red at an
interval of 2 seconds,
indicating
that
charging
has begun.
It will turn off when the charging
is
completed.
Access
lamp [ACCESS]
O
• When this unit is accessing
the SD
card or built-in
memory,
the access
lamp lights up.
1)
Open the LCD monitor.
• Check that the access
lamp has gone off.
2)
Open the SD card/terminal
cover and
insert
(remove)
the SD card into (from)
the card slot.
• Face the label side Q in the direction
shown
in the illustration
and press it
straight
in as far as it will go.
• Press the center
of the SD card and then
pull it straight
out.
3)
Securely
close the SD card/terminal
cover.
• Securely
close it until it clicks.
13
VQT3K69
Advertisement
Table of Contents
