How To Set Up Your Tractor; Check Battery; To Roll Tractor Off Skid; Install Seat - Craftsman EZ3 917.271141 Owner's Manual

HOW TO SET UP YOUR TRACTOR
CHECK BATTERY
o Lift seat pan to raised position and
open battery box door.
° if this battery is put into service after
month and year indicated on label
(label located between terminals)
charge battery for minimum of one hour
at 6-t0 amps, (See "BATTERY" in
MAINTENANCE section of this manual
for charging instructions),
Battery Box
Door
Label
Termin_
INSTALL SEAT
Adjust seat before tightening adjustment
knob.
* Remove adjustment knob and flat
washer securing seat to cardboard
packing and set aside for assembly of
seat to tractor°
o Pivot seat upward and remove from the
cardboard packing, Remove the
cardboard packing and discard.
, Place seat on seat pan and assemble
shoulder boll Tighten shoulder bolt
securely_
o Assernble adjustment knob and flat
washer loosely. Do not tighten,
o Lower seat into operating position and
sit on seat,
, Slide seat until a comfortable position is
reached which allows you to press
clutch/brake pedal all the way down,
, Get off seat without moving its adjusted
position.
o Raise seat and _ighten adjustment knob
securely_ ,/_=_ _
Shoulder Bolt J_-----,,_ l"
-"'---.
/ ._i _ Flat Washer
Adjustment Knob
NOTE: You may now roll or drive you
tractor off the skid. Follow the appropriate
instruction below to remove the tractor
from the skid.
TO ROLL TRACTOR OFF SKID (See
Operation
section for location and
function of controls)
• Press lift lever plunger and raise
attachment lift lever to its highest
position.
o Release parking brake by depressing
clutch/brake pedal.
• Place freewheel control in freewheeling
position to disengage transmission
(See '%0 TRANSPORT" in the Opera-
tion section of this manual)..
o Roll tractor forward off ski&
• Remove banding holding discharge
guard up against tractor,
TO DRIVE TRACTOR OFF SKID (See
Operation section for location and
function of controls)
_,WARNING: Before starting, read,
understand and follow all ins]ructions in
the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be
sure the area in front of tractor is clear of
other people and objects.
• Be sure all the above assembly steps
have been completed.
- Check engine oil level and fill fuel tank
with gasoline.
• Place freewheel control in "transmis-
sion engaged" position.
, Sit on seat in operating position,
depress clutch/brake pedal and set the
parking brake
° Place motion control lever in neutral (N)
position.
• Press lift lever plunger and raise
attachment lift tever to its highest
position,
° Start the engine. After engine has
started, move throttle control to idle
position,
° Release parking brake.
• Slowly move the motion control lever
forward and slowly drive tractor off skid,
• Apply brake to stop tractor, set parking
brake and place motion control lever in
neutral position.
• Turn ignition key to "OFF" position,
Continue with lhe instructions that follow,