To Adjust Brake; To Replace Motion Drive Belt; Transmission Removal/Replacement; Transaxle Motion Control/Lever Neutral Adjustment - Craftsman EZ3 917.271141 Owner's Manual

Mandrel
Pulley Idter
_andret
%
-... --:-
<j
TO ADJUST BRAKE
Your tractor is equipped with an adjust-
able brake system which is mounted on
the side of the transaxle,
If tractor requires more than six (6) feet
stopping distance at high speed in
highest gear, then brake must be
adjusted.
• Depress clutch/brake pedal and
engage parking brake_
• Measure distance between brake
operating arm and nut "A" on brake
rod.
° If distance is other than 1-9/16", loosen
jam nut and turn nut "A" until distance
becornes 1-9/16", Retighten jam nut
against nut "A".
• Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6) feet in highest
gear, further maintenance is neces -
sary,, Contact your nearest authorized
service center/departmenL
With Parking Brake "Engaged"
,Jam Nut
3erating
Arm
Do not touch this nut. If further brake
adjustment is necessary contact your
nearest authorized service center/department
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom
side of left footrest.
• Remove mower (See "TO REMOVE
MOWER" in this section of this manual )
o Remove belt from stationary idter and
clutching idler,
• Pull belt slack toward rear of tractor
Carefully remove belt upwards from
transmission input pulley and over
cooling fan blades.
° Pull belt toward front of tractor and
remove downward from around engine
pulley.
o install new belt by reversing above
procedure.
Engine Pulleys= __'_}_
Clutching Idler _" _14(_i I'_'''
Stationary Idler'
"7_i t
Transmission
_;:;__
TRANSMISSION REMOVAL/REPLACE-
MENT
Should your transmlssion require removal
for service or replacement, it should be
purged after reinstallation and before
operating the tracton See "PURGE
TRANSMISSION" in the Operation section
of this manual
TRANSAXLE MOTION CONTROL
LEVER NEUTRAL ADJUSTMENT
The motion control lever has been preset
at the factory and adjustment should not
be necessary°
• Loosen adjustment bolt in front of the
right rear wheel, and lightly tighten.
° Start engine and move motion control
lever until tractor does not move
forward or backward.
• Hold motion control lever in that
position and turn engine off.
o While holding motion control lever in
piace, loosen the adjustment bolt.
23