Download Print this page

Craftsman 358.794300 Instruction Manual page 6

25cc/1.5 cu.in. 2-cycle 185 mph/385 cfm gasoline powered blower/vac

Advertisement

Available languages

Available languages

SHOULDER STRAP ADJUSTMENT
(for vacuum use only)
1. Hold the unit as shown.
2. Pass the shoulder strap over your
head and onto your right shoulder.
3. Extend your left arm toward the
rear of the vacuum bag.
4. Adjust shoulder strap until the vac-
uum bag/shoulder
strap seam lies
between your thumb and index
finger.
5. Make sure air flows freely from the
elbow tube into bag. If bag is kinked,
the unit will not operate properly.
KNOW
YOUR
BLOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare
the illustrations
with your unit to familiarize
yourself
with the location
of the various
controls
and adjustments.
Save this manual
for future
reference.
Upper
T_
Vacuum
Lower
Vacuum Tube
PrimerBu_on
Vacuum Bag
_/_
,
T hrotWe__
Lever
Elbow Tube
Spark Plug--:4,'._
TBI°L
wer
Choke Lever
_,,
Fuel Mix
Fill Cap
_Staprle
r
'_Rear
Handle
THROTTLE LEVER
The THROTTLE LEVER is used to select
the desired engine speed and to stop the
engine. Move the throttle lever to the
position for full speed operation.
Move the throttle lever to the-_
posi-
tion for idle speed. To stop the engine,
move the throttle lever to the STOP posi-
tion.
PRIMER BUTTON
The PRIMER BUTTON removes air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the starter
rope. Activate primer button by pressing
it and allowing it to return to its original
position.
CHOKE LEVER
The CHOKE helps to supply fuel to the
engine to aid in cold starting. Activate
the choke by moving the choke lever to
the FULL CHOKE position. After engine
attempts to start, move the choke lever
to the HALF CHOKE position. Once en-
gine starts, move choke lever to the
RUN position.
-6-

Advertisement

loading