Table of Contents
Advertisement
Section 3
Assembly
Shaft Grip
(4) Screws =_
_
_1_
Shaft
==
Housing
==
=,
Minimum 6 inches
(15i24 cm)
D-Handle
Bottom Clamp
(4) Nuts .......
Fig, 3-1
(if used)
Install and Adjust the D-handle
1.
Remove the screws and bottom ciamp piece that
were installed on the D-handle for shipping.
2.
Place D-handle over the shaft housing and onto the
bottom clamp (Fig. 3-1). Place it a minimum of 6
inches (15.24 cm) from the end of the shaft grip.
3.
Start screws with a large Fiat-head or T-25 Torx
screwdriver.
Do not tighten until you make the
handle adjustment.
4.
If it was pre-installed,
loosen the screws on the
D-handlejust
enough to move the D-handle.
5. While holding the unit in the operating position
(Fig. 3-2), move the D-handle to the location that
provides you the best grip.
6. lighten
the clamp screws evenly, until the D-handle
is secure.
Fig. 3-2
¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸7¸
Hide quick links:
Advertisement
Table of Contents
