Table of Contents
Advertisement
Maintenance (continued)
Loop
Fig, 6-7
Holding Slots
Spring
Fig, 6-8
12. insert the ends of the Iine into the two holding slots
(Fig. 6-7).
13. insert the ends of the iine through the eyelets in the
outer spooi and piace inner reel with spring inside the
outer spooi (Fig. 6-8). Push the inner reet and outer
spool together. While holding the inner reel and outer
spooI, grasp the ends and pull firmty to release the
line from the holding slots in the reel.
NOTE: The spring must be assembled on the inner
reel before reassembling
the cutting
attachment.
14. Hold the inner reel in place and instaIt the Bump
Knob by turning counterclockwise.
Tighten securely.
Installing a Pie Wound Reel
1.
Hold the outer spooi with one hand and unscrew the
Bump Knob clockwise (Fig. 6-1). Inspect the bolt
inside the Bump Knob to make sure it moves freely.
Replace the Bump Knob if damaged.
2.
3.
Remove the old inner reel from the outer spool
(Fig. 6-1).
Remove the spring from the otd inner reel
(Fig. 6-1).
4.
Place the spring in the new inner reel.
NOTE: The spring must be assembled on the inner
reel before reassembling
the cutting
attachment.
5.
insert the ends of the line through the eyelets in the
outer spool (Fig. 6-8).
.
Place the new inner reel inside the outer spool
Push
the inner reel and outer spoot together. White holding
the inner reel and outer spoot, grasp the ends and
pulI firmly to release the line from the holding slots in
the spool.
7.
Hold the inner reel in place and install the Bump
Knob by turning counterclockwise,
lighten
securely.
Replacement Parts
For replacement parts, refer to the Accessories/
Replacement Parts section,
14
Hide quick links:
Advertisement
Table of Contents
