Table of Contents
Advertisement
Available languages
Available languages
Adding
E ngineOil
1.
Make sure pressure washer is on a Ievei surface.
2.
Check oii ievel as described in Checking Oif Level
3.
If needed, siowiy pour oil into oil tiff opening to the
"Full" mark on dipstick. DO NOToverfill.
Overfiiiing with oil may cause the engine to not start, or
hard starting.
DONOT overfill.
If overthe FULLmarkon dipstick,drainoil to reduceoil levelto
FULLrnarkon dipstick.
4.
Replaceand tigilten dipstick.
ChangingEngine Oil
Changeengine oii after the first 5 hours and every 50 hours
thereafter, if you are using your pressure washer under
extremely dirty or dusty conditions, or in extremely hot
weather, change oil more often.
CAUTION
Avoid prolonged or repeatedskin contact with used motor
oil,
Usedmotoroil hasbeenshownto causeskin cancerin certain
laboratory animals.
Thoroughly washexposed areaswith soapandwater.
KEEPOUT OFREACHOFCHILDREN.DON'T
POLLUTE.CONSERVE RESOURCES. RETURN
USEDOIL TO COLLECTION CENTERS.
Changeeli while ee_.iieeis still warm from terminal, as
fellows:
1.
Drain fuel tank by running pressure washer until fuel
tank is empty.
2.
Disconnect spark plug wire and keep it away from spark
plug.
3.
Cteanarea around oii fiii, remove oil fill cap/dipstick.
Wipe dipstick clean.
4.
Tip your pressure washer to drain oii from oii fiii into a
suitable container making sure you tip your unit away
from spark piug. When crankcase is empty, return
pressure washer to upright position.
5.
Siowiy pour recommended oii (about 18 oz.)into oii fiil
opening. Pauseto permit oil to settle. Fill to "Full" mark
on dipstick.
6.
Wipe dipstick clean each time oil levet is checked. DO
NOT overfiii.
7.
Replaceand tighten dipstick.
8.
Wipe up any remaining oil.
9.
Reconnect spark plug wire to spark plug.
Service Air Cleaner
Your engine wiii not run properly and may be damaged if you
run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of operation or
once each year, whichever comes first. Service more often if
operating under dirty or dusty conditions. Replacementsare
available at your local Searsservice center.
"t'eservice the air eleanor, feiiew those dope:
1.
Removescrew (A).
2.
Carefuliy remove air cteaner assembly to prevent debris
from failing into carburetor.
3.
Take air cleaner assembiy apart and clean aii parts.
Wash foam air cteaner (B) in liquid detergent and water.
Squeezedry in a clean ctoth.
4.
SATURATE foam air cieaner in engine oil and squeezein
a clean cloth to remove excess oil.
5.
Reinstall clean or new foam air cleaner in base (C).
6.
Instaii air cleaner securely on carburetor with screw.
NOTE:You can purchase new air filter elements by calling
l=800=4=MY=NO_,'IE
(469-4663),
Service Spark Plug
Service the spark plug every 100 flours of operation or
yearly, whichever occurs first.
1.
Cleanarea around spark piug.
2.
Removeand inspect spark ptug.
3.
Repiacespark piug if eiectrodes are pitted, burned or
porcelain is cracked. Use the recommended replacement
plug. See Specifications.
4.
Checkelectrode gap with wire feeier gauge and set spark
plug gap to 0.030 inch (0.76 mm) if necessary.
\
5.
Instaii spark piug and tighten firmly.
NOTE:You can purchase a new spark plug by calling
l=800o4=MY=NOME ( 469o4663),
19
Advertisement
Table of Contents
