Table of Contents
Advertisement
HOW TO SET UP YOUR TRACTOR
CHECK
BATTERY
• Lift hood to raised position,
• if this battery is put into sewice after
month and year indicated on label
(label located between
terminals)
charge battery for minimum of one
hour at 6-10 amps. (See =BATTERY"
in Maintenance
section of this manual
for charging instructions).
-'
.o-'
'
Label
f
INSTALLSEAT
Adjust seat before tightening adjustment
knob,
• Remove adjustment
knob and flat
washer securing seat to cardboard
packing and set aside for assembly of
seat to tractor.
• Pivot seat upward and remove from
the cardboard
packing, Remove
the
cardboard packing and discard.
• Place seat on seat pan and assemble
shoulder bolt. Tighten shoulder bolt
securely.
• Assemble
adjustment
knob and flat
washer loosely.
Do not tighten.
• Lower seat into operating position
and sit on seat.
• Slide seat until a comfortable
position
is reached which allows you to press
clutch/brake
pedal all the way down.
• Get off seat without moving its
adjusted
position.
• Raise seat and tighten adjustment
knob securely.
Seat
Seat Pen
Shoulder
Bolt _,,
._._..
NOTE: You may now roll or drive you
tractor off the skid. Follow the appropria
instruction below to remove the tractor
from the skid.
TO ROLLTRACTOR
OFF SKID (Se
Operation
section for location and
function
of controls)
• Press lift lever plunger and raise
attachment lift lever to its highest
position
• Release parking brake by depressin
clutch/brake pedal.
• Place freewheel control in freewheel
ing position to disengage transmissi,
(See "TO TRANSPORT" in the Oper_
tion section of this manual).
• Roll tractor forward off skid.
• Remove banding holding discharge
guard up against tractor
TO DRIVE TRACTOR OFF SKID
(See Operation section for locatio,
and function of controls)
_I_WARNING:
Before startinq read,
understand and fo ow a
ns'[ruct ons ,
the Operation section of this manual. B_
sure tractor is in a well-ventilated
area.
Be sure the area in front of tractor is
clear of other people and objects.
• Be sure all the above assembly step=
have been completed.
• Check engine oil level and fill fuel
tank with gasoline.
• Place freewheel
control in "transmis-
sion engaged"
position.
• Sit on seat in operating position,
depress clutch/brake
pedal and set
the parking brake.
• Place motion control lever in neutral
(N) position.
• Press lift lever plunger and raise
attachment
lift lever to its highest
position.
• Start the engine. After engine has
started, move throttle control to idle
position.
• Release
parking brake.
Flat
Adjustment
Washer
Knob
8
Advertisement
Table of Contents
