Craftsman EZ3 917.270921 Owner's Manual page 32

TROUBLESHOOTING CHART
PROBLEM
Poor grass
discharge
Headlight(s) not
working
(if so equipped)
Battery will not
charge
Loss of drive
Engine "backfires"
when turning
engine
"OFF"
CAUSE
• Engine speed too slow.
• Travel speed too fast.
• Wet grass.
• Mower deck not level.
• Low/uneven tire air pressure.
• Wom, bent or loose blade.
• Buildup of grass, leaves and
trash under mower.
• Mower drive belt worn.
• Blades improperly installed.
• Improper blades used.
• Clogged mower deck vent
holes from buildup of
grass, leaves, and trash
around mandrels.
• Switch is =OFP.
• Bulb(s) burned out.
• Faulty light switch.
• Loose or damaged wiring.
• Blown fuse.
• Bad battery cell(s).
• Poor cable connections.
• Faulty regulator
(if so equipped).
• Faulty altemator.
• Freewheel control in
=disengaged" position.
• Motion drive belt wom,
damaged, or broken.
• Air trapped in transmission
during shipment or
servicing.
• Engine throttle control not
set at "SLOW _
position for 30 seconds
stopping engine.
CORRECTION
• Place throttle control in
=FAST" position.
• Shift to slower speed.
• Allow grass to dry before
mowing.
• Level mower deck.
• Check tires for proper air
pressure.
• Replace/sharpen blade.
Tighten blade bolt.
• Clean underside of mower
housing.
• Replace mower drive belt.
• Reinstall blades sharp edge
down.
• Replace with blades listed in
this manual.
• Clean around mandrels to
open vent holes.
•Tum switch =ON".
• Replace bulb(s).
• Check/replace light switch.
• Check wiring and connec
tions.
• Replace fuse.
• Replace battery,
• Check/clean all connections.
• Replace regulator.
• Replace aitemator.
• Place freewheel control in
=engaged" position.
• Replace motion drive belt.
• Purge transmission.
• Move throttle control to
=SLOW" position and allow
to idle for 30 seconds before
stopping engine.
32