EPSON Perfection 610
6. Disconnect the connector for the Inverter Lamp from the Inverter
Board.
7. Remove the black screw and disconnect the 2-pin connector for the
CCD sensor, and then remove the Inverter Board.
8. Remove the Inverter Lamp from the carriage cover.
When installing the Inverter Lamp, locate the
connectors correctly as shown in the following
figures.
Assembly and Disassembly
Inverter Board
Disassembly Procedures
Connector
Black Screw
Connector (2-pin)
Figure 4-10. Inverter Board Removal
Carriage Cover
Connector (2-pin)
Figure 4-11. Inverter Lamp Removal
Revision B
Inverter Lamp
31