Other Problems; The Touch Panel Screen Is Difficult To View; You Were Logged Out Without Having Performed Logout Yourself; You Forgot The Administrator Password - Sharp MX-2300G Troubleshooting Manual

Other Problems

Problem
The touch panel
screen is difficult to
view.
You were logged out
without having
performed logout
yourself.
You forgot the
administrator
password.
When the main power
is switched off, the
main power indicator
on the operation panel
does not turn off.
Point to check
Is the display contrast properly
adjusted?
Did Auto Clear activate?
Was the administrator password
changed from the factory default
setting?
Has the power has been turned off by
pressing the [POWER] key (
the operation panel and has a certain
amount of time elapsed since then?
Adjust the contrast using "Display Contrast" in the
system settings.
➞ System Settings > "Default Settings" > "Display
Contrast"
When user authentication is used, the currently logged
in user will be automatically logged out if Auto Clear
activates. (Except when in PC scan mode.)
Log in again.
If you are the administrator, you can change the time
setting of Auto Clear or disable Auto Clear in "Auto
Clear Setting".
➞ System Settings (Administrator) > "Operation
Settings" > "Auto Clear Setting"
Contact your dealer or nearest authorised service
representative.
* For the factory default administrator password, see "TO
THE ADMINISTRATOR OF THE MACHINE" in the
Safety Guide. After changing the password, take special
care to remember it.
If the main power is switched off more than
) on approximately one minute after the power has been
turned off by pressing the [POWER] key (
operation panel, the main power indicator on the
operation panel will not turn off immediately. (The
indicator will remain on for approximately another
minute. This is normal and does not indicate a failure.)
Solution
) on the
35