Turnaround Polling; Being Polled (Polling Standby); Polling Security - Sharp FO-225 Operation Manual

-\
POLLING
Turnaround Polling
.
After polling a machine, you can send a document to it on the same connection. Simply place the
document to be sent in the feeder and carry out the
polling
procedure. When polling is finished,
the document will be automatically transmitted.
})
Note:
The other wchine must also have Turnaround Polling capability.
Being polled (Polling Standby)
To let another machine poll your machine, simply set the Reception mode switch to AUTO, and
loadthe document(s)to be sent in the usual fashion.
Transmission will take place when the other machine calls your machine and activates polling.
Automatic reception is possible while your machine is on polling standby.
Polling Security
Polling Security is used to prevent unauthorized polling of your machine. When this function is
activated, polling will only take place when one of the following conditions is met:
The fax number of the polling machine has been entered into your machine as
having permission to poll you. (The polling machine must also have its fax number
programmed in itself, as described in "Entering your name and fax number" in
Chapter 2.)
The polling machine has an ID number (see "Entering ID numbers for polling
permission" which follows in this section), and this number has been entered into
your machine as having permission to poll you.
>>
Important:
ID numbers can only be used ~~theotherfa mchine is also a Shap machine.
POLLING
5-3