Setting The Video System - Sharp Notevision XG-C58X Operation Manual

Setting the Video System

The video input system mode is preset to "Auto"; however, a clear picture from the con-
nected audio-visual equipment may not be received, depending on the video signal differ-
ence. In that case, switch the video signal.
Setting the Video
System
Select "Video System" in the "Options
(1)" menu on the menu screen.
➝ For operating the menu screen, see
pages 42 to 45.
Note
• The video signal can only be set in IN-
PUT 3 or INPUT 4 mode.
• When the system mode is set to "Auto",
you may not receive a clear picture due
to signal differences. Should this occur,
switch to the video system of the source
signal.
-66 -66
PAL When connected to PAL video equipment.
SECAM When connected to SECAM video
equipment.
NTSC4.43 When reproducing NTSC signals in
PAL video equipment.
NTSC3.58 When connected to NTSC video equipment.