Sharp AR-M236 Software Setup Manual page 10

!!install_ar230270.book 8 ページ ２００４年２月１９日 木曜日 午後１時１７分
INSTALLING THE SOFTWARE
11
When the interface selection screen
appears, select "USB" and click the
"Next" button.
12
A confirmation window appears. Check
the contents and then click the "Next"
button.
13
Click the "Next" button.
In Windows 98/Me, click the "Yes" button.
Begin installation of the printer driver.
In Windows 2000, if the following
Caution
screen appears while the files are
being copied (the message may
appear more than once), click the
"Yes" button.
14
When "The installation of the SHARP
software is complete" appears, click the
"OK" button.
8
15
Click the "Close" button.
A message will appear instructing you to
connect the machine to your computer.
Click the "OK" button.
After the installation, a message
Note
prompting you to restart your
computer may appear. In this case,
click the "Yes" button to restart your
computer.
16
Make sure that the power of the machine
is turned on, and then connect the USB
cable. (p. 12)
Windows will detect the machine and the
Plug and Play screen will appear.
17
Follow the instructions in the Plug and
Play screen that appears in your version
of Windows to begin the installation.
This completes the installation of the
software.
After installation, see "CONFIGURING THE
PRINTER DRIVER" (p. 13) to check the printer
driver settings.