Sharp AN-PR1500H Operation Manual page 58

Timer and sleep operation (Remote Control only) (continued)
AN-PR1500H
7
Set the time to finish as in steps 5 and 6 above.
8
Switch input with the
MEMORY/DIMMER button.
To select the timer playback source: DVD/CD, USB, DIGITAL 1, DIGITAL 2,
DIGITAL 3, LINE 1, LINE 2, LINE 3, SCART or TUNER.
When you select the tuner, select a station by pressing the
button, and then press the MEMORY/DIMMER button.
If a station has not been programmed, "NO PRESET" will be displayed
and timer setting will be cancelled.
9
Adjust the volume using the VOLUME control, and then press the
MEMORY/DIMMER button.
Do not turn the volume up too high.
10
Press the ON/STAND-BY button to enter the power stand-by
mode.
The "TIMER" indicator lights up and the unit is ready for timer playback.
11
When the preset time is reached, playback will start.
The volume will increase gradually until it reaches the preset volume.
12
When the timer end time is reached, the system will enter the
power stand-by mode automatically.
Once timer:
The timer will be cancelled.
The "r" indicator will blink during timer playback.
Daily timer:
The timer will operate at the same time every day. It will continue until the daily
timer setting is cancelled. Cancel the daily timer when it is not in use.
The "DAILY r" indicator will blink during timer playback.
58
or button, and then press the
Note:
When performing timer playback using another unit connected to the USB terminal/
DIGITAL 1/DIGITAL 2/DIGITAL 3/LINE 1/LINE 2/LINE 3/SCART sockets, select
USB or DIGITAL 1 or DIGITAL 2 or DIGITAL 3 or LINE 1 or LINE 2 or LINE 3 or
SCART in step 8.
This unit will turn on or enter the power stand-by mode automatically. However, the
connected unit to USB terminal/DIGITAL 1/DIGITAL 2/DIGITAL 3/LINE 1/LINE 2/
LINE 3/SCART sockets will not turn on or off.
or
Checking the timer setting in the timer stand-by mode:
1 Press the CLOCK/TIMER button.
2 Within 10 seconds, press the
press the MEMORY/DIMMER button.
3 Within 10 seconds, press the
CALL", and press the MEMORY/DIMMER button.
The unit returns to the timer stand-by mode after displaying the settings in order.
Cancelling the timer setting in the timer stand-by mode:
1 Press the CLOCK/TIMER button.
2 Within 10 seconds, press the
press the MEMORY/DIMMER button.
3 Within 10 seconds, press the
OFF", and press the MEMORY/DIMMER button.
Timer will be cancelled (the setting will not be cancelled).
Reusing the memorised timer setting:
The timer setting will be memorised once it is entered. To reuse the same setting,
perform the following operations.
1 Turn the power on and press the CLOCK/TIMER button.
2 Within 10 seconds, press the
press the MEMORY/DIMMER button.
3 Within 10 seconds, press the
and press the MEMORY/DIMMER button.
4 Press the ON/STAND-BY button to enter the power stand-by mode.
or button to select "ONCE" or "DAILY", and
or button to select "ONCE CALL" or "DAILY
or button to select "ONCE" or "DAILY", and
or button to select "ONCE OFF" or "DAILY
or button to select "ONCE" or "DAILY", and
or button to select "ONCE ON" or "DAILY ON",