G Misfeed In The Large Capacity Tray; Misfeed In The Large Capacity Tray - Sharp AR-C262M Operation Manual

Misfeed in the large capacity tray

When a misfeed occurs in the large capacity tray, remove the misfed paper, following the procedure below.
While holding the tray release lever,
1
carefully slide the large capacity tray away
from the main unit until it stops.
Release lever
Remove any misfed paper from the main
2
unit and the large capacity tray.
Upper right
side cover
Open the top cover.
3
4 Remove the misfed paper.
If the misfed paper is
stuck inside the machine
and cannot be removed,
open the side cover and
then remove the misfed
paper. (See "Misfeed in
the transport area,
fusing area, and exit
area" on page 2-20.)
Be sure not to tear the
misfed paper during
removal.
After removing the
misfed paper, close the
top cover.
Push the large capacity tray towards the
5
main unit and latch it into place.
If misfed paper is not found in step 2, pull
6
the tray out.
Remove the misfed paper.
7
8 Gently push the tray back into place.
LARGE CAPACITY TRAY
Gently push the large
capacity tray back in
until it stops.
The paper feed table
automatically rises to the
paper feed position.
Make sure that the
paper misfeed screen is
cleared and the normal
message screen
appears.
3-17
3