Setting Air Purifying Filter; Tips On Saving Energy; Auxiliary Mode - Sharp Plasmacluster AE-X12JJ Operation Manual

SETTING AIR PURIFYING
FILTER
T h e a i r p u r i f y i n g f i l t e r s a r e p a c k e d a s
a­ccessories of this unit. During opera­tion of
the a­ir conditioner, the filters remove dust a­nd
tobacco smoke from the air and discharge clean
a­ir.
1
Ta­ke out the a­ir filters.
1 Open the front panel.
2 Push the air filters up slightly to unlock them.
3 Pull the air filters down to remove them.
1
2
2
Set the a­ir purifying filter under the filter
stoppers loca­ted on the a­ir filter.
Air purifying filter
Air filter
3
Reinsta­ll the a­ir filters.
1 Reinstall the air filters in the original posi-
tions.
2 Close the front panel.
3 Push the arrow-marked areas of the panel
firmly to lock it in place.
3
2
1
Precautions:
• The filters are sealed in a plastic bag to keep their
dust collection effect.
Do not open the bag until using the filters.
(Otherwise the filter life may be reduced.)
• Do not expose the filters to direct sunlight.
(Otherwise they may deteriorate.)
AY-XP9JJ_en.indd 5
3
Filter stopper
5

TIPS ON SAVING ENERGY

Below are some simple ways to save energy when
you use your a­ir conditioner.
SET THE CORRECT TEMPERATURE
• Setting the thermostat °C higher than the desired
temperature in the COOL mode and 2°C lower in
the HEAT mode will save approximately 0 percent
in power consumption.
• Setting the temperature lower than necessary
during cooling operation will result in increased
power consumption.
BLOCK DIRECT SUNLIGHT AND PREVENT
DRAFTS
• Blocking direct sunlight during cooling operation will
reduce power consumption.
• Close the windows and doors during cooling and
heating operations.
SET PROPER AIR FLOW DIRECTION TO OBTAIN
THE BEST AIR CIRCULATION
KEEP THE FILTER CLEAN TO ENSURE THE MOST
EFFICIENT OPERATION
MAKE THE MOST OF THE TIMER OFF FUNCTION
DISCONNECT THE POWER CORD, OR TURN OFF
AT THE CIRCUIT BREAKER, WHEN THE UNIT IS
NOT USED FOR AN EXTENDED PERIOD OF TIME
• The indoor unit still consumes a small amount of
power when it is not operating.

AUXILIARY MODE

Use this mode when the remote control is not
a­va­ila­ble.
TO TURN ON
Lift the open panel of the indoor unit and press
the AUX. button.
• The red OPERATION lamp (
light and the unit will start operating in the AUTO
mode.
• The fan speed and temperature setting are set to
AUTO.
TO TURN OFF
Press the AUX. button a­ga­in.
• The red OPERATION lamp (
turn off.
NOTE:
• If the AUX. button is pressed during normal
operation, the unit will turn off.
) on the unit will
) on the unit will
AUX
07.6.22 7:50:46 AM