Timer On - Sharp Plasmacluster AE-X12JJ Operation Manual

Before setting the timer, make sure the clock is properly set with the current time.

TIMER ON

1
Press the TIMER ON (
2
The TIMER ON indicator will blink; press
the TIME ADVANCE or REVERSE button
to set the desired time.
(The time can be set in 0-minute increments.)
3
Point the remote control at the receiver
window on the unit and press the TIMER
SET (SET/C) button.
• The orange TIMER lamp (
light.
• The unit will generate a beep when it receives
the signal.
4
Select the opera­tion condition.
DISPLAY
MODE
FAN
NOTE:
• The unit will turn on prior to the set time to allow
the room to reach the desired temperature by the
programmed time. (Awaking function)
AY-XP9JJ_en.indd 11
) button.
) on the unit will
1
1h
CLEAN
2
3
SET/C
TO CANCEL TIMER MODE
Press the TIMER CANCEL (SET/C) button.
• The orange TIMER lamp (
off.
• The current clock time will be displayed on the
remote control.
MODE
CLEAN
FAN
NOTE:
• If any TIMER ON, TIMER OFF and ONE-HOUR
OFF TIMER are set, the TIMER CANCEL button
cancels all settings.
TO CHANGE TIME SETTING
Ca­ncel the TIMER setting first, then set it a­ga­in.
COMBINED USE OF ON AND OFF
TIMERS
You can use the ON and OFF timers in
combina­tion.
Example:
To stop operation at :00 p.m. and resume operation
to bring the room temperature to the desired level by
7:00 a.m.
1
Set the TIMER OFF to 11:00 p.m. during
opera­tion.
2
Set the TIMER ON to 7:00 a­.m.
The arrow ( or
indicator and the TIMER OFF indicator shows
which timer will activate first.
NOTE
:
• You cannot programmed the ON-TIMER and OFF-
TIMER to operate the unit at different temperatures
or other settings.
• Either timer can be programmed to activate prior
the other.

) on the unit will turn
1h
CANCEL
SET/C
) between the TIMER ON
07.6.22 7:50:49 AM