Epson dreamio EMP-TW2000 User Manual page 27

The colour mode selected
Locking/Unlocking the Memory
when the memory was
registered is displayed on the
TIP
right side.
Memory settings that have
been applied to images will be
retained even when the
projector's power is turned off.
The same memory adjustment
settings will be applied to
images that are projected the
next time the projector's power
is turned on.
The aspect
from memory may not be
applied to the images if they
are 16:9 images or if the input
signal images have a particular
resolution.
Erase Memory
This feature can be used to erase and clean up
unwanted memories.
Press , and select "Erase Memory".
The Erase Memory screen will be displayed.
Select the memory name to erase.
A confirmation message will be displayed. If
you select "Yes", the memory will be erased.
The contents of a locked memory cannot be
deleted. Perform deletion once the lock has
been released.
To erase all saved memories, select "Reset" -
"Reset Memory" in the Configuration menu.
p.35
It is not possible to erase a locked memory by
selecting "Reset" - "Reset Memory" in the
Configuration menu.
Viewing Images at a Preset Image Quality(Memory Function)
setting retrieved
Locking/Unlocking the Memory
Among the registered memories, the eight from
ISFDayR to ISFNightX can be locked.
Press , and select "Save Memory ".
The Save Memory screen will be displayed.
Select the name of the memory to be
locked, press and hold the
the remote control for at least 7 seconds,
and then, within 4 seconds, press
twice.
Once a memory has been locked,
displayed to the left of the memory name, as
shown below.
When a locked memory is called, "Image"
cannot be adjusted.
To release the lock on a memory,
select the name of the memory to
release, press and hold the
TIP
button on the remote control for at
least 7 seconds, and then, within 4
seconds, press
button on
is
twice.
25