Craftsman 917.28925 Operator's Manual page 22

3. ATTACH MOWER SIDE S USPENSION
ARMS (A) T O CHASSIS - Position hole
inarm over p in(B) o noutside oftractor
chassis and secure with retainer spring.
4. Repeat onopposite side
of tractor.
7. Insert end of link (E) into hole in front
mower bracket (H) and secure with
washer and retainer spring (J).
5,
ATTACH REAR LIFT LINKS (C) - Lift
rear corner of mower and position slot
in link assembly over pin (D) on rear
mower bracket and secure with washer
and retainer spring.
8. Hook end of clutch cable spring (Q) into
hole in idler arm (R).
9. Push clutch cable housing guide (P) into
bracket, slide collar (L) onto guide and
secure with retainer spring (K),
10. Install belt onto engine pulley (M) and belt
keepers (G).
6,
ATTACH FRONT LINK (E) - Work from
left side of tractor. Insert rod end of link
assembly through front hole in tractor
front suspension bracket (F).
IMPORTANT: Check belt for proper routing
in all mower pulley grooves.
11.Raise attachment lift lever to highest
position.
12. If necessary, adjust gauge wheels before
operating mower as shown inthe Opera-
tion section of this manual.
03042rex
22