Table of Contents
Advertisement
1-800=944=9044
(United States)
1=800=265=8352
(Canada)
Visit our web site at
www.crosley.com
CONCERN
POTENTIAL
CAUSE
i
COHHON
SOLUTION
AUTOHATIC
ICE HAKER
Ice maker
is not mak-
•
Ice maker power switch is Off.
•
Turn power switch to On ('T') position.
ing any ice.
•
Ice maker has small cube
•
Remove small cube from ice maker. The ice and water
caught in mechanism,
filter cartridge may be clogged.
Replace filter cartridge.
•
Saddle valve on cold water
•
Turn off household water line valve. Remove valve. En-
pipe is clogged or restricted by
sure that valve is not a self-piercing saddle valve. Clean
foreign material,
valve. Replace valve if necessary.
Ice maker
is not mak'
'
:[ce maker is producing less ice
•
The ice maker produces approximately
nine (9)pounds
of
lag enough
ice,
than you expect,
ice every 24 hours depending on usage conditions,
Checkto see if water dispenser
:[fit iS; rep!ace the ice and water fi!ter cartridge:
is dispensing slower than normal
ice maker
will
not stop
•
Ice maker wire signal arm is
•
Move item and release wire signal arm. Remove any ice
making
ice.
being held down by some item
cubes that are frozen together over the wire signal arm.
in the freezer.
Ice cubes are freezing
,
:[ce cubes are not being used
•
Remove ice container and discard ice from container. :[ce
together,
frequent!y enough:
maker will produce fresh supply.
-:[ce
cubes are hollow (partially
•
The ice and water fi ter cartridge may be clogged: Replace
frozen cubes with water inside):
filter cartridge:
•
Freezer control is set too warm.
•
Set freezer control to colder setting. Allow
24 hours for
-
temperature to stabilize.
ICE DISPENSER
Dispenser will not dis-
pense ice.
•
:[ce storage container is empty.
•
Freezer temperature
is set too
warm.
•
Household water line valve is
not open.
-
:[ce dispensing arm has been held
in for more than 4-5 minutes.
Ice dispenser
is
jammed.
•
Icehas melted and frozen
around auger due to infrequent
use, temperature
fluctuations,
and/or power outages.
•
Ice cubes are jammed between
ice maker and back of ice
container.
•
When the first supply of ice is dropped into the container,
the dispenser should operate.
•
Turn freezer control to a higher setting so that ice cubes
will be made. When first supply of ice is made, dispenser
should operate.
•
Open household water line valve. Allow sufficient time
for the ice to be made. When ice is made, the dispenser
should operate.
,
Motor is overloaded.
Motor over load protector will reset in
approximately 3 minutes.
:[ce can then be dispensed.
•
Remove ice container, thaw, and empty the contents.
Clean container, wipe dry, and replace in proper position.
When new ice is made, dispenser should operate.
•
Remove ice cubes that are jamming the dispenser.
OPENING / CLOSZNG OF DOORS I DRAWERS
Door(s) will not close.
•
Door was closed too hard, caus-
ing other door to open slightly.
•
Refrigerator is not level. [t
rocks on the floor when moved
slightly.
•
Refrigerator is touching a wall
or cabinet.
Drawers
are difficult
tO
'
Food is touching shelf on LoP of
move:
drawer.
•
Track that drawers slide on is
•
Close both doors gently.
•
Ensure floor is level and solid, and can adequately support
the refrigerator.
Contact a carpenter to correct a sagging
or sloping floor.
•
Ensure floor is level and solid, and can adequately support
the refrigerator.
Contact a carpenter to correct a sagging
or sloping floor.
Remove top !ayei of items in drawer.
•
Ensure drawer is properly installed on track.
•
Clean drawer, rollers, and track,
See Care & Cleaning,
dirty.
Advertisement
Table of Contents
