Crosley W10338608B Use And Care Manual page 8

7, Select WATER LEVEL
MDBJM LARGE
WATER LEVEL
9, Select options
OPTIONS
Select the water level setting most suitable for your load.
Small will add a low amount of water for smaller loads and
Super will add the most amount of water for large or bulky
loads. Items need to move freely.
O, Select WASH TEMPERATURE
COOL WARM
WASHTEMPERATURE
ALL COLD RI_'¢SES
Once you select a cycle, select the desired wash temperature
by turning the Wash Temperature knob to the appropriate
setting based on your load. All rinses are tap cold.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
Not
Some cold water is added to save Whites and pastels
energy. This will be cooler than Durable garments
your hot water heater setting. Heavy soils
Warm
Some cold water will be added, so Bright colors
this will be cooler than what your Moderate to light soils
Cool
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
Colors that bleed
or fade
Cold
This is the temperature from your Dark colors that
faucet. If your tap cold water is bleed or fade
very cold, warm water may be Light soils
added to assist in soil removal
and help dissolve detergent.
Select the desired cycle options. If you are using fabric
softener, be sure to select one of the Fabric Softener Added
options.
10.
Press START/PAUSE to begin
wash cycle
START
Q
Hold3 sec
PAUSE to cancel
Press the START/PAUSE button to start the wash cycle. Filling
is delayed for several minutes while load balance is sensed.
When the cycle has finished, the DONE indicator will light.
Promptly remove garments after cycle has completed to avoid
odor, reduce wrinkling, and rusting of metal hooks, zippers,
and snaps.
Unlocking the lid to add garments:
If you need to open the lid to add 1 or 2 missed garments:
Press START/PAUSE; the lid will unlock once the washer
movement has stopped. This may take several minutes if the
load was spinning at high speed. Then close lid and press
START/PAUSE again to restart the cycle.
If lid is left open for more than 10 minutes, the water will pump
out automatically.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for load
unbalance. You will hear the hum of the spin prior to filling.
This is normal operation.
8