Crosley W10338608B Use And Care Manual page 12

TROUBLESHOOTING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
f
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
Washer won't run
or fill, washer stops
working or wash light
remains on (indicating
that the washer was
unable to fill
appropriately) (cont.)
Washer not draining/
spinning, loads
are still wet, or spin
light remains on
(indicating that the
washer was unable to
pump out water within
10 minutes)
Check proper electrical supply.
Normal washer operation.
Washer may be tightly packed.
Empty pockets and use garment
bags for small items.
Use a cycle with a low spin speed.
The washer may be tightly packed or
unbalanced.
Check plumbing for correct drain hose
installation. Drain hose extends into
standpipe farther than 4.5" (114 mm).
Plug power cord into a grounded 3=prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: Hfproblems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer spins the dry load for severn minutes before filling to
determine if load is balanced. You may hear the hum of the
spins. This is normal.
Remove several items, rearrange load evenly in basket, and add
detergent. Close lid and press START/PAUSE.
Do not add more than 1 or 2 additional items after cycle has
started to avoid tightly packing or unbalancing.
SmNI items may have been caught in pump or between basket
and tub, which can slow draining.
Cycles wil:_'llower spin speeds remove less water than cycles ........................
with high spin speeds. Use the recommended cycle/speed spin
for your garment. To remove extra water in the load, select Drain
& Spin. Load may need to be rearranged to allow even
distribution of the load in the basket.
Tightly packed or unbalanced loads may not allow the washer
to spin correctly, leaving the load wetter than normal= Evenly
arrange the wet load for balanced spinning. Select the Drain
& Spin cycle to remove excess water. See "Using Your Washer"
for loading recommendations.
Check drain hose for proper installation. Use drain hose form
and securely attach to drainpipe or tub. Do not tape over drain
opening= Lower drain hose if the end is higher than 96" (2.4 m)
above the floor. Remove any dogs from drain hose.
Too much detergent causing suds to Always measure and follow detergent directions for your load=
slow or stop draining and spinning. To remove extra suds, select Rinse & Spin. Do not add detergent.
12