Settings" Menu; Direct Power On; Sleep Mode; Child Lock - Epson dreamio EH-TW2800 User Manual

Configuration Menu Functions

"Settings" menu

Direct Power On

When the main power switch is turned on, you can set for projection to start (On) / not start (Off) without
pressing
When set to "On" with the main power switch left on, be aware that sudden surges of electricity that may
occur when the power comes back on after a power outage may cause the projector to turn on.

Sleep Mode

The projector is equipped with a power-saving function that causes the power to turn off automatically
and the projector to switch to standby if no signal is input to the projector for a continuous length of time.
The length of time before the power-saving function operates can be selected from four available settings.
If "Off" is selected, the power-saving function will not operate.
If you press

Child Lock

This locks the power on function of the
cannot accidentally turn the projector's power on and look into the projector's lens. When the lock is
applied, the power will only turn on if
turn off the power, and the remote control will continue to operate as normal.
If you change the setting, the new setting will take effect after the power has been turned off and the cool-
down period is complete.
Even if "Child Lock" is set to "On", be aware that projection starts merely by turning the main power
switch on when "Direct Power On" is set to "On".

Control Panel Lock

If this is set to "On", you can't operate the projector's control panel buttons and a
screen when a button is pressed. To cancel, press and hold
seven seconds or more.
If you change the setting, the new setting will take effect after exiting the configuration menu.

Trigger Out

This turns the trigger function on and off to determine whether the projector's power on/off status and
problems with projector operation are communicated to an external device.
If you change the setting, the new setting will take effect after the power has been turned off and the cool-
down period is complete.
High Altitude Mode
A fan is set at a certain speed of rotation so as to bring down internal temperature.
When using above an altitude of about 1500m, set to "On".
Projection
This should be set in accordance with the method used to set up the projector.
• Front
• Front/Ceiling : Select when the projector is set up in front of the screen and suspended from a ceiling.
• Rear
• Rear/Ceiling : Select when the projector is set up behind the screen and suspended from a ceiling.
36
or .
while the projector is in standby mode, projection will start again.
: Select when the projector is set up in front of the screen.
: Select when the projector is set up behind the screen.
button on the projector's control panel, so that a child
is pressed down for about 3 seconds.
on the projector's control panel for about
can be used to
icon appears on the