Craftsman 351.215080 Operator's Manual page 12

KightFax 9110/2003 10:38 PAGE 13141 RiEhtFax
WARNING: After sanding wood or nonmetallic material,
always clean dust collector and guards of sawdust be_re
gdnding metal. Sparks could ignite debris and cause a fire.
Be cedain motor is kept clean and is frequently vacuumed
free of dust,
Use soap and water to cleanpainted parts, rubberparts and
ptast_c guards.
LUBRICATION
The shielded ball bearings in this tool are perr_nen@y
lubricated at the factory. They require no further lubrication.
• Perlodlcatly grease the worm (Figure 31, Key No. 4) or
Figure 30, Key No. 1) and worm gear (Figure 30 or 33, Key
No. 34) and adjustment rod (Figure 29, Key No, 31 or
Figure 32, Key No, 30).
• Perlodisally grease the spindle (Figure 30, Key No. 10 or
Figure 33, Key No. 12) at the base, at the worm (Figure
30, Key No. 11 or Figure 33, Key No, 13) end gear on the
main shaft (Figure 29, Key No. 21 or Figure 32, Key No.
22) that meshes with the worm.
• When operation seems stiff, a light coat of paste wax
applied to the belt, disc end spindle tables will make It
easier to feed the work while finishing.
• Do not apply wax to the belt platen. Belt could pick up wax
and deposit it on wheels causing belt to slip.
KEEP TOOL IN REPAIR
• If power cord Is worn, cut, or damaged in any way, have it
replaced Immediately.
• Replace worn abrasives when needed,
• Replace any damaged or missing parts, Use parts list to
order parts.
Any attempt to repair motor may create a hazard unless
repair is dane by a quaJified service technician. Repair ser-
vice is available at your nearest Sears store.
12