Squaringthesaw Bladeto The Fence - Craftsman 315.212330 Operator's Manual

SQUARINGTHESAW BLADETO THE FENCE
See Figures 24 - 27.
[] Unp(ug the saw.
[] Pul( the saw arm all the way down and engage the lock
p(n to hold the saw arm (n transport pos(tion.
[] Loosen the miter (ock handle.
[] Rotate the miter tame unt(( the po(nter is pos(tioned
at O.
[] Retighten the miter (ock handle.
[] Lay a framing square flat on the miter table. P(ace one
(eg of the square against the fence. S(ide the other (eg
of the square against the flat part of b(ade.
NOTE: Make sure that the square contacts the flat part
of the blade, not the blade teeth.
[] The edge of the square and the blade shou(d be paraF
(el as shown in figure 24.
[] (f the front or back edge of the blade angles away from
the square as shown in figures 25 and 26, adjustments
are needed.
[] Using an 8 mm wrench, loosen the hex screws that
secure the mounting bracket to the miter table.
[] Rotate the mounting bracket (eft or right unti! the Made
is paraHe( with the square.
[] Retighten the screws securely and recheck the blade-
to-fence a(ignment.
FENCE
BLADE
FENCE
BASE
BASE
FRAM(NG
SQUARE
V(EWOFBLADENOTSQUARE W(TH
FENCE,ADJUSTMENTS ARE REQUIRED
VIEW OF CLADENOTSQUAREW(TH
FENCE,ADJUSTMENTS AREREQUIRED
BLADE
Fig. 25
BLADE
Fig. 26
8 mm SOCKET
, HEADSCREW(S)
V(EWOF BLADE
SQUARE W(TN FENCE
F(g. 24
22
[V](TER
TABLE
F(g. 27