Table of Contents
Advertisement
_
WARNING:Before performing a nyadjustment,
makesurethetool isunplugged f romthe power
supply andthe switchis
in the OFF position. Failure
to heed this warning could result in serious personal
injury.
The compound
miter saw has been adjusted at the fac=
tory for making very accurate cuts. However, some of the
components
might have moved out of alignment during
shipping. Also, over a period of time, readjustment will
probably become necessary due to wear. After unpacking
the saw, check the following adjustments
before you
begin using the saw. Make any readjustments that are
necessary and periodically check the parts alignment
to make sure that the saw is cutting accurately.
DEPTH
STOP
See Figure 45.
The depth stop limits the blade's downward travel. Ht
allows the blade to go below the miter table enough to
maintain full cutting capacities. The depth stop positions
the blade 1/4 in. from the miter table support.
NOTE: The miter table support is located inside the miter
table.
The depth stop is factory set to provide maximum cutting
capacity for the 10 in. saw blade provided with the saw.
Therefore, the saw with blade provided should never need
adjustments.
However, when the diameter of the blade has been re=
duced due to sharpening, it may be necessary to adjust
the depth stop to provide maximum cutting capacity. Also,
when a new blade is installed, it is necessary to check the
clearance of the blade to the miter table support before
starting the saw. Make adjustments
if needed.
POSITIVE8TOP
ADJUSTMENT
8CBEW FOB
O°ANGLE$
LOCK
NUT(8)
Fig. 44
PIVOT ADJUSTMENTS
NOTE: These adjustments were made at the factory and
normally do not require readjustment.
TRAVEL
PIVOT ADJUSTMENT
[] The saw arm should rise completely to the up position
by itself.
[] If the saw arm does not raise by itself or if there is play
in the pivot joints, have saw repaired by a qualified
service technician at your nearest Sears Service Center
to avoid risk of personal injury.
BEVEL
PIVOT ADJUSTMENT
[] The compound miter saw should bevel easily by loos-
ening the bevel lock knob and tilting the saw arm to the
left.
[] If movement is tight or if there is play in the pivot, have
saw repaired by a qualified service technician at your
nearest Sears Service Center to avoid risk of personal
injury.
32
HEXNUT
Fig. 45
CAUTION:
Do not start the compound
miter saw
without checking for interference between the blade
and the throat plate. Damage could result to the
blade if it strikes the throat plate during operation of
the saw.
Advertisement
Table of Contents
