Craftsman 315.108620 Operator's Manual page 17

,_ WARNING: Do not stare into thetaserbeams or
turn the laserson when the tool is not in use, Failure
to do so couldresult in possible serious personal
tnjur/_
USING THE LASER GUIDES
See Figures 15- 16.
The laser guides will generate a red colored laser beam
on the work surface in front of and behind the saw when
turned on, The front laser or Virtual Edge Guide can be
ad}usted for use as an edge guide w_h a scale of 0 - 6 ino
The rear laser afdes in aligning plunge cuts and following
the kerf when exiting the workpiece.
NOTE: The laser units come from the factory atready
installed and aUgned, If the rear laser guide becomes
misaligned after time, refer to the Adjustments section for
realignment instructions_The Virtual Edge Guide requires
no further alignment,
m Mark the line of cut on the workpiece.
= Push in and turn the Virtual Edge Guide adjustment
knob until the needle is aligned to the desired position
on the Virtual Edge Guide sca_e,
la Adjust the depth and angle of the cut as needed
m Plug the tool into a power supply and press the laser
gutde button to activate the _aser,
m Start the motor.
NOTE; Do not touch the blade to the workplece until
the saw has reached maximum speed,
[] Slowly push the saw forward into the workpiece.
NOTE: Keep the laser beam on the marked line on the
workpiece for precision cutting,
= Once the cut is complete, allow the saw to come to a
complete stop before turning off the taser.
= Unplug the saw,
LASERGUIDEBUTTON
REAR LASER GUIDE
LASER GUIDE DUTTDN
VIRTUAL E DGE GUIDE
ALIGNMENT NEEDLE
Fig, 16
"',, VIRTUAL E DGE GUIDE
ADJUSTMENT KNOB
VIRTUAL
EDGE GUIDE
Fig, 15
17