Assembly; Installing Extension Wings And Arm Brackets; Installing The Dust Bag; Installing The Hold-Down Clamp - Craftsman 137.212150 Operator's Manual

ASSEMBLY INSTRUCTIONS
To avoid injury, do not connect this miter saw to the
power source until it is completely assembled and
adjusted, and you have read and understood this
Operators Manual.
INSTALLING EXTENSION WINGS & ARM
BRACKETS (FIG. A)
1. Slide the extension wing (1) into the mounting holes
(2) of the saw base.
2. Thread the locking screw (3) into the extension wing
then tighten with a Phillips screwdriver.
3. Place one flat washer (4) onto one lock knob (5),
insert through the arm bracket (6) and thread into the
extension wing. Repeat for second lock knob.
4. Thread the extension wing lock knob (7) into the
threaded hole in the base (8) to lock the extension
wing into place.
5. Repeat steps 1 through 4 for right side extension.
NOTE: The arm brackets serve two purposes: To act
as a stop block for repetitive cuts and to level the
workpiece when the extension wings are fully extended
for additional work support (see Operation for details).
Fig. A
J
7
6
4 1
5
\
3
INSTALLING THE DUST COLLECTION ELBOW
(Fig. B)
1. Install the larger end of the elbow (1) onto the
exhaust port (2).
NOTE: The elbow can be used to attach either the dust
bag or a vacuum hose to remove sawdust from the
work area.
Fig. B
INSTALLING THE DUST BAG (Fig. C)
1. Squeeze the metal collar wings (1) of the dust bag
(2).
1. Place the dust bag neck opening around the exhaust
port (3), and release the metal collar wings.
Fig. C
INSTALLING THE HOLD-DOWN CLAMP (Fig. D)
1. Loosen two lock knobs (1) in each side on the rear
.
3.
Fig. D
of the saw base (2).
Place the Hold-down Clamp (3) on either the left or
right mounting hole (4).
Tighten the lock knob to secure the clamp in place.
©
4