Belt Guard - Craftsman 917.295451 Owner's Manual

SERVICE AN ADJUSTME , TS
TO REMOVE BELT
GUARD (See Fig. 22)
o Remove two (2) cap nuts and washers from side of belt
guard.
o Loosen (do not remove) fine shield nut on underside of
tine shield..
o Pull belt guard out and away from unit.
- Replace belt guard by reversing above procedure. Be
sure slot in bottom of belt guard is under head of tine
shield bolt and all nuts are tightened securely.
CAP N UTS
WASHERS
BELT
GUARD
TINE SHIELD NUT
FIG. 22
ENGINE
TO ADJUST CARBURETOR (See Fig. 23)
The carburetor has a high speed fixed jet and has been
preset at the factory and adjustment should not be neces-
sary. However, minor adjustments may be required to
compensate for differences in fuel, temperature, altitude or
load. If the carburetor does need adjustment, proceed as
follows.
In general, turning the idle needle valve in (clockwise)
decreases the supply of fuel to the engine giving a leaner
fuel/air mixture. Turning the needle valve out (counter-
clockwise) increases the supply of fuel to the engine giving
a richer fue!/air mixture..
IMPORTANT: DAMAGE TO THE NEEDLES AND THE
SEATS IN CARBURETOR MAY RESULT IF SCREWS
ARE TURNED fN TOO TIGHT
PRELIMINARY SETTING
o Air cleaner assembly must be assembled to the carbu-
retor when making carburetor adjustments.
o With engine off, turn idle needle valve in (clockwise)
closing it finger tight and then turn valve out (counter-
clockwise) 1-1/2 turns
FINAL SETTING
o Start engine and allow to warm for five minutes Make
final adjustments with engine running at idle and line
control lever in "OFF" position
o With throttle contro! in "SLOW" position, turn idle needle
valve in (clockwise) until engine begins to die then turn
out (counterclockwise) until engine runs rough_ Turn
valve to a point midway between those two positions
IDLE RPM ADJUSTMENT
o To adjust idle RPM, rotate throttle linkage counter-
clockwise and hold against stop while adjusting idle
speed adjusting screw to obtain 1750 RPM Release
throttle linkage
ACCELERATION TEST
o Move throttle control lever from "SLOW" to "FAST"
position. If engine hesitates or dies, turn idle needle
valve out (counterclockwise) 1iSturn. Repeattestand
continue to adjust, if necessary, until engine acceler-
ates smoothly
High speed stop is factory adjusted Do not adjust or
damage may result.
IMPORTANT: NEVER TAMPER WITH THE ENGINE
GOVERNOR, WHICH IS FACTORY SET FOR PROPER
ENGINE SPEED OVERSPEEDtNG THE ENGINE ABOVE
THE FACTORY HIGH SPEED SETTING CAN BE
DANGEROUS IF YOU THINK THEENGINE-GOVERNED
HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR
NEAREST SEARS SERVICE CENTER/DEPARTMENT,
WHICH HAS PROPER EQUIPMENT AND EXPERIENCE
TO MAKE ANY NECESSARY ADJUSTMENTS
THROTTLE LINKAGE
THROTTLE STOP
IDLE SPEED
ADJUSTING SCREW IDLE NEEDLE VALVE
FIGo23
17