Operation - Craftsman 315.175010 Owner's Manual

OPERATION
TO INSTALL DUST BOX
See Figure 23,
1. Unplug your plate joiner.
2. Realigrldust poxwithmarof plate joiner, Groovesladust
box align with rails on plate joiner.
3. Slide dust box on plate joiner as shown by the arrow in
figure 23, YOUwill feel a soft click as the tabs snap into
place, NOTE: As mentioned previously, be careful not
to break the tabs that secure dust box to plate joiner,
GROOVES
DOS .°o
Fig. 23
HELPFUL HINTS
/ Always clamp workplace securely before cutting.
/ A safe operator Is one who thinks ahead.
/ Always wear eye protection when cutting slots.
/ Make set-upadjustments carefully. Then doublecheck.
Measure twice and cut once.
J Always dry assemble your project before gluing it
together.
,/ The more biscuits used, the stronger the joint will be.
/ Keep blade clean and properly sharpened.
/ Don't let familiarity make you careless.
,/ Study all safety nJlas and do the job safely.
/ NEVER place your hands in jeopardy.
/ Make certain clamps can't loosen while in use.
/ Test dlfficuff set-ups on scrap--Don't waste lumber.
/ Plan each operation before you begin.
/ Provide for smoother operation by cleaning your plate
jolaer frsquendy. Sheke plete joiner or blowwith an air
Jetto remove wood particle build*up.
,/ dO NOT ABUSE POWER TOOLS. Abusive practioes
can damage tool as well as workpiece.
/ "n,IINK SAFETY BY THINKING AHEAD,
EXTENSION CORDS
The use ofany extension cord willcause some loss of power,
TO keep the loss to a minimumand to prevent tool overheat-
ing, follow the recommended cord sizes on the chart below.
When tool is used outdoo,'s,use only extension cords suit-
able for outdooruse and so marked. Outdoor use extension
cords are marked with the letters 'WA" on the cord'sjacket,
Extension cords are available at Sears Retail Stores,
Extension Cord Length Wire Size A.W.G.
0-25 Feet 18
25-100Feet 16
t_rr_J_l Keep extension cords away from the cutting
area and position the cord so that it will not get caught on
lumber, tools, etc. dudng cutting operations.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrica-
tion is required.
Page 16