Advertisement
Available languages
Available languages
41_WARNING:
Make sure the lock-
ing/release button is locked in the pri-
mary hole and the knob is securely
tightened
before operating
the unit.
All attachments
are designed
to be
used in the primary hole.
For optional
attachments,
see the AS-
SEMBLY section of the applicable
at-
tachment
instruction
manual.
ATTACHING
SHIELD
_WARNING:
The shield must be
properly installed. The shield provides
partial protection to the operator and
others from the risk of thrown objects,
and is equipped with s line limiter blade
which cuts excess line to the proper
length. The line limiter blade (on under-
side of shield) is sharp and can cut you.
For proper orientation of shield, see
KNOW YOUR TRIMMER illustration in OP-
ERATION section.
1.
Remove wing nut from shield.
2.
Insert bracket into slot as shown.
3.
Pivot shield until bolt passes
through hole in bracket.
4. Securely tighten wing nut onto bolt,
Bracket -_
(_
Slot _X_/
%ingNut
Shield
ADJUSTING
THE HANDLE
_WARNING:
When adjusting the
assist handle, be sure it remains
above the safety label and below the
mark or arrow on the shaft.
1. Loosen wing nut on handle.
2.
Rotate the handle on the shaft to an
upright position; retighten wing nut,
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT Compare the illustrations with your unit to familiarize
yourself with the location
of the various controls and adjustments, Save this manual for future reference.
Trimmer
Head
Coupler
Shaft
\
Assist
Handle
J
/ Shield
"
/
Line Umiter Blade
ON/OFF Switch
Throttle /
Starter Handle
Trigger
ON/OFF SWITCH
The
ON/OFF switch
is located
on the
trigger handle and is used to stop the
engine,
Move the switch
to the OFF
position to stop the engine.
CHOKE
The CHOKE helps to supply fuel to the
engine to aid in cold starting, Activate the
choke by moving the red choke lever to
the FULL CHOKE position.
Spark Plug
Choke
_/
_¢"Muffler
,
Oil fill /
Primer Bulb "_-_
Qipstick
PRIMER
BULB
The PRIMER BULB removes air from
the carburetor
and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope, Activate
the primer bulb
by pressing
it and allowing
it to return
to its original
form.
COUPLER
The COUPLER enables
optional
at-
tachments
to be installed on the unit.
9
Advertisement
