Craftsman 358.350370 Instruction Manual page 19

2.2 cu.in./36cc 2-cycle gasoline chain saw
Table of Contents

Advertisement

TROUBLESHOOTING
TABLE
_,
WARNING:
Always
stop unit and disconnect
spark plug before perform-
ing all of the recommended
remedies below except remedies
that require
TROUBLE
REMEDY
1. Move ON/STOP switch to ON.
Engine will not
start or will run
only a few
seconds
after
starting.
Engine will
not idle
properly.
Engh_e will not
accelerate,
lacks power.
or dies under
a load.
Engine
smokes
excessively.
Engine
runs
hot.
operation
of the unit.
CAUSE
1. ON/STOP
switch
in
STOP position.
2. Engine flooded.
3. Fuel tank empty.
4. Spark plug not firing.
5. Fuel not reaching
carburetor.
6. Carburetor
requires
adjustment.
7. None of the above.
1. Idle speed set too high
or too low.
2. Low Speed Mixture
requires
adjustment.
3. Crankshaft
seals worn.
4. Compression
_ow.
5. None of the above.
1. Air filter dirty.
2. Spark plug fouled.
3. Carburetor
requires
adjustment.
4. Exhaust
ports or muf-
fler outlets
plugged.
5. Compression
low.
6. Chain brake engaged.
7. None of the above.
1. Choke
partially on.
2. Fuel mixture
incorrect.
3. Air filter dirty.
4. High Speed Mixture
requires
adjustment.
5. Crankcase
leak.
1. Fuel mixture
incorrect.
2. Spark
plug incorrect.
3. High Speed Mixture
set too lean.
4. Exhaust
ports or muf-
fler outlets
plugged.
5. Carbon
build-up
on
spark arresting
screen.
6. Starter housing dirty
7. None of the above.
2. See "Difficult Starting"
in the
Operation
Section.
3. Fill tank with correct fuel mixture.
4. Instatl new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
6. See "Carburetor
Adjustment"
in the
Service and Adjustments
Section.
7. Contact
Sears Service.
1. See "Carburetor
Adjustment"
in the
Service and Adjustments
Section.
2. See "Carburetor
Adjustment"
in the
Service and Adjustments
Section.
3. Contact
Sears Service.
4. Contact
Sears Service.
5. Contact
Sears Service.
1. Clean or replace
air filter.
2. Clean or replace
plug
and regap.
3. See "Carburetor
Adjustment"
in the
Service and Adjustments
Section.
4. Contact
Sears Service.
5,
6.
7.
1.
2.
Contact
Sears Service.
Disengage
chain brake.
Contact
Sears Service.
Adjust
choke.
Empty fuel tank and refill with
correct
fuel mixture.
Clean or replace
air filter.
See "Carburetor
Adjustment"
in the
Service
and Adjustments
Section.
Contact
Sears Service.
5,
1. See "Fueling
Engine" in the Operation
section.
2. Replace with correct
plug.
3. See "Carburetor
Adjustment"
in the
Service
and Adjustments
Section.
4. Contact
Sears Service.
5. Clean spark arresting
screen.
6. Clean starter housing
area.
7. Contact
Sears Service.
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents