Advertisement
Available languages
Available languages
APPLICATIONS
Asatrimmer:
•
Cutting g rass a ndlight w eeds
Muffler
Edging
\
Spark Plug
•
Decorative
trimming
around
trees,
fences,
etc.
\
/
#
Other
optional
accessories
may be used with this unit.
Shaft Grin
_-'_./,/
,
_
._'_._._\
Starter Hope
ContreOn'O",
\
I Y .-4
°...°. \
Cutting Head Shield
Cutting Head
iNSTALL CUTTING HEAD SHIELD
_L_
ARNING:
To prevent serious personal injury, never operate
the trimmer without the cutting head shield in place.
Use the following
instructions
if the cutting attachment
shield on the unit is
not installed. Use only the instructions
that apply to the type of shaft and
shield that the unit is equipped with.
1.
Place the cutting head shield
onto the shaft housing. Be
sure the guard mounting
bracket slides into the slot on
the edge of the cutting
shield. Rotate the shield into
place, counterclockwise
(Fig.
1). The holes in the guard
mounting bracket and cutting
head shield will line up.
2.
From inside the cutting head
shield, push the square bolt
through the hole until the
threaded end protrudes
through the guard mounting
bracket (Fig. 2).
3.
Put the washer on the bolt,
then screw the wing nut onto
the bolt and tighten.
Cutting
Head Shield
Mount
Bracket
Fig. f
Washer
Nut
Square
Bolt
iNSTALL AND ADJUST THE D-
HANDLE
1.
Push the D-handle down
onto the shaft housing (Fig.
3). The hex bolt hole in the
Shaft Grip
Shaft Housing
side.
Minimu in.
wing
2.
Insert the bolt into the hex
hole in the handle and push
(15.24 era) _'_
Nut
through. Place the washer on
dO_
"\
the bolt, then screw the wing
Bolt _
Washer
nut onto the bolt. Do not
Fig. 3
tighten until making the
handle adjustment.
3.
Rotate the D-handle to place the grip above the top of the shaft
housing.
Place it a minimum of 6 inches (15.24 cm) from the end of the
shaft grip.
4.
While holding the unit in the operating
position (Fig. 11), move the D-
handle to the location that provides the best grip.
5.
Tighten the wing nut until the D-handle is secure.
Fig. 2
Advertisement
